Oil
rig drilling is world-wide operation and solids control machinery
and system is manufacture t that it can be operate on any corner of the
world, land and sea
alike. As been one of the most hazard working- area condition, the electronic parts of machinery often
marked "IECEX/A-TEX". This is the certificate marked as Hazardous
Area Certifications. The mainstream mark
is IECEX which is international which every country accept the standard while
ATEX is European standard but most countries are accept the standard as
well.
Explosive
atmospheres can be caused by possible burning gases, mists, vapors or by combustible
dusts, in combination with oxygen. With a certain concentration density all
that is needed to cause an explosion is a source of fire cause by heat and
spark.
ATEX
or IECEX certified machinery will secure the operators and its machinery assets
that under no matter in any working condition it will not cause an ignition so
in conclusion it is safe, end of discussion.
The standard divided into different zones that ID potential hazardous
atmosphere in the area.
ATEX
based on the requirements of two European Directives:
1. Directive 99/92/EC (also known as ‘ATEX 137’
or the ‘ATEX Workplace Directive’) is minimum requirements for improving the
health and safety protection of workers potentially at risk from explosive
atmospheres.
2. Directive 94/9/EC (also known as ‘ATEX 95’ or
‘the ATEX Equipment Directive’) on the approximation of the laws of Members
States concerning equipment and protective systems intended for use in potentially
explosive atmospheres.
What
IECEX Scheme is an international Conformity Assessment Scheme covering
Electrical Equipment for Explosive Atmospheres, as the internationally accepted
means of demonstrating conformity with IEC Standards prepared by IEC TC31.
ATEX
standard is about enabling to trade in European countries. Its purpose is to
establish a level of safety which is to be regarded it is sufficient to ensure
European authorities would accept the equipment certified.
Difference
compare with ATEX, the IECEX is about giving confidence that a product or
service meets clearly defined transparent criteria. By providing its
transparency with a high level of confidence, it is intended that it will
eventually provide a worldwide recognized and acceptance certificate in which
the whole world has confidence. The driving force is safety, with the trade
benefits following from the confidence.
GN
Solids Control China factory introduced many advanced processing machines from
developed countries like European,and USA.And our factory processing team are
very experienced. So our production is very effiecient.We can manufacture a
whole solids control system needed equipments in a short time. Welcome
you contact GN group
freely for solution
Related Posts
没有评论:
发表评论